Live signal heatmaps turn WiFi troubleshooting from a guessing game into a map - down to the exact operator, timestamp and access point.
Zero setup to trial. Install the APK on a handful of devices and you're live - no integration project, no waiting on IT.
A network survey tells you what coverage looked like on the day someone walked around with a tool. It doesn't tell you what's happening today - or who it's slowing down right now.
No dedicated survey hardware, no scheduled visit. The agent your team already runs for Identity captures signal data continuously, as a side effect of normal scanning.
WiFi and cellular RSSI captured automatically, timestamped, tied to the device, the operator, and the exact location.
No batch upload, no end-of-day sync - readings appear in Analytics and on the floorplan heatmap as they happen.
Set your own RSSI threshold in the portal, plus how many times it has to be crossed before you get notified - then it's a proactive email, not a dashboard you have to watch. The same threshold-and-frequency alerting is available for CT Identity too, not just Network.
15:03 - Operator Luc reports his scanner dropped connection while picking at location 23-3-5.
CT Network shows exactly what happened: Luc's device was connected to Access Point 2, and signal strength had already crossed the Critical WiFi Signal threshold (below ‑85 dBm) two minutes before the drop.
It's not a one-off. Pulling the last 7 days: this exact alert fired 26 times, always in Zone A, across different operators - a pattern, not bad luck.
The fix, found the same day: boost the transmit power on Access Point 2. Coverage in Zone A improves immediately, and the alert stops firing.
This becomes a vague complaint, a 2-week survey request, and - if you're lucky - a fix a month later for a problem that's already cost dozens of stalled scans.
Scheduled, planned, executed once. Tells you what coverage looked like on the day it ran - not what's happening the day after.
The operator, timestamp, location, access point and exact signal reading are in the portal the moment it happens - and the pattern across a week is visible immediately.
WiFi and cellular signal strength gets captured automatically alongside every barcode scan - building a live, granular picture of coverage across your entire floor.
An interactive floorplan overlays live WiFi strength and scanning activity onto your actual racking layout - built in minutes with the built-in editor and an Excel import.
Every data point plotted by GPS coordinate, with heatmap overlays for signal strength and most-visited locations.
A traditional one-time wifi site survey is billed as a fixed-scope project, and you're paying again every time you need updated data. CT Network replaces that recurring cost with a one-time €2,500 setup and a subscription from €8/user or €100/warehouse per month - for continuous coverage data, not a single snapshot.
A scheduled survey typically takes about two weeks from request to results, and it only reflects conditions on the day it ran. CT Network needs no scheduling - install the agent on a handful of devices and live coverage data starts appearing the same day.
A wifi heatmap overlays signal strength onto your floorplan, zone by zone, so dead spots are immediately visible instead of relying on scattered complaints from your team days or weeks after the fact.
First pin down exactly where and when signal drops below a usable threshold - CT Network logs this automatically per access point and zone, the way it did for Zone A in the example above. Most dead zones are then fixed by adjusting access point placement or transmit power, once you know precisely where to look.
Portal access is secured with Microsoft AD B2C authentication, including two-factor authentication (2FA), for extra protection of your data.
